Replacing The Lamp; Closing The Door; Installation - AEG SKS51200S1 Notice D'utilisation

10 www.aeg.com
Problem

7.2 Replacing the lamp

1. Disconnect the plug from the mains
socket
2. At the same time, with the fingers
expand up and down the transparent
cover and unhook it in the direction
of the arrows.
2
3. Replace the lamp with one of the
same power and shape, specifically

8. INSTALLATION

8.1 Positioning
This appliance can be installed in a dry,
well ventilated indoor where the ambient
temperature corresponds to the climate
class indicated on the rating plate of the
appliance:
If the advice does not lead
to the desired result, contact
the nearest Authorised
Service Centre.
1
1
Possible cause
The food products' tem-
perature is too high.
Many food products are
stored at the same time.
The door has been
opened often.
There is no cold air circula-
tion in the appliance.
designed for household appliances.
(the maximum power is shown on the
light bulb cover).
4. Reassemble the lamp cover.
5. Connect the plug to the mains
socket.
Open the door. Make sure that the light
comes on.

7.3 Closing the door

1. Clean the door gaskets.
2. If necessary, adjust the door. Refer to
"Installation".
3. If necessary, replace the defective
door gaskets. Contact the Authorised
Service Centre.
Climate
class
SN
N
ST
Solution
Let the food products temper-
ature decrease to room tem-
perature before storage.
Store less food products at the
same time.
Open the door only if necessa-
ry.
Make sure that there is cold air
circulation in the appliance.
Ambient temperature
+10°C to + 32°C
+16°C to + 32°C
+16°C to + 38°C