GreenWorks Commercial Tools GD40TCS Manuel D'utilisation page 10

EN
DE ES IT FR PT NL RU FI SV NO DA PL CS SK SL HR HU RO BG EL AR TR HE LT LV ET
PROBLEM
Bar and saw
chain running
hot and
smoking.
Motor runs,
but chain is not
rotating.
Motor runs,
chain rotates
but does not
cut.
English (original instructions)
TROUBLESHOOTING
POSSIBLE CAUSE
Check saw chain tension for
overtightened condition.
No oil in the oil tank.
The discharge port is
blocked by debris.
Oil tank is blocked by debris. Clean out the oil tank and refill with
Bar and chain oil tank cap is
blocked by debris.
The sprocket or guide
wheels is clogged with
debris.
Saw chain tension is too
tight.
Check guide bar and saw
chain assembly.
Check guide bar and saw
chain for damage.
Dull chain.
Chain on backwards.
Chain tension could be
overtightened or too loose.
SOLUTION
Tension saw chain.
Refill oil into the oil tank.
Refer to the manual to remove the bar
and clean out the debris.
clean oil.
Clean the debris off the oil cover.
Clean and remove debris from sprocket
and guide wheel.
Refer to Saw Chain Tension Guide
earlier in this manual.
Refer to Page 5.
Remove the battery from the unit. Take
the bar cover off, and remove the bar
and saw chain. Clean all debris from
the top handle saw. After all debris is
cleared, insert battery and run the top
handle saw. If the sprocket is spinning
your motor is okay. If the sprocket is not
spinning, call customer service.
Sharpen or replace the saw chain.
Refer to Replacing the Bar and Saw
Chain assembly earlier in this manual.
Refer to Re-tensioning the saw chain in
the manual.
9