GreenWorks Commercial Tools GD40TCS Manuel D'utilisation page 11

EN
DE ES IT FR PT NL RU FI SV NO DA PL CS SK SL HR HU RO BG EL AR TR HE LT LV ET
Top handle saw
does not start.
Motor running,
but cutting
abnormal.
English (original instructions)
The chain brake is engaged. Pull the chain brake towards you until
No electrical contact
between the top handle saw
and battery.
The battery pack is depleted. Charge the battery pack.
The battery and power tool
is too hot or too cold.
Motor stops after about 10
seconds.
If the unit cuts off and
beeps during a cut, it went
into protection mode. This
protects the PCB from
damage.
Battery is not charged.
The saw chain needs
lubrication, and will increase
friction if not properly
maintained.
Incorrect battery storage
temperature.
the chain brake is disengaged.
To secure the battery, make sure the
latches on the battery compartment
snap into place.
Refer to the battery and charger
maintaince part in the manual.
Recharge the battery.
Release the trigger and restart the top
handle saw. Let the top handle saw do
the work and do not force the cut.
Charge the battery. Refer to the battery
and charger manual for correct charging
procedures.
Make sure the chain is always lubricated
by never letting the bar and chain oil run
low.
Allow the battery pack to cool until it
drops to room temperature.
10