GreenWorks Commercial Tools GD40TCS Manuel D'utilisation page 3

EN
DE ES IT FR PT NL RU FI SV NO DA PL CS SK SL HR HU RO BG EL AR TR HE LT LV ET
11. Wrench
12. Top handle
13. Sprocket cover tighten nuts
14. Sprocket cover
15. Chain tensioner adjustment screw
16. Bolt for saw chain tension
17. Sprocket
18. Battery release button
19. Oil outlet
20. Bar groove
21. Chain drive links
22. Cutter
23. Felling direction
24. Danger zone
25. Escape route
26. Direction of fall
27. Notch
28. Felling back cut
29. Hinge
30. Limb cut
31. Keep work off ground leave support
limbs until log is cut
32. Log supported along the entire length
33. Cut from top (over buck) avoid cutting
earth
34. Log supported one end
35. Under buck
36. Over buck
37. Log supported both ends
38. Bucking a log
39. Stand on uphill side when cutting be-
cause log may roll
English (original instructions)
ASSEMBLY
This top handle saw requires no assembly,
but user should know how to assemble the
guide bar and saw chain. Check the chain
tensioning and add oil as described later in
this manual before each operation.
ASSEMBLING THE GUIDE BAR AND
SAW CHAIN See figure 2 - 7
Make sure remove the battery pack from
the unit. Wear protective gloves.
Unscrew the sprocket cover tighten
„
nuts and remove the sprocket cover.
The saw chain should face in the
„
direction of chain rotation. If they face
backwards, turn the loop over.
Place the chain drive links into the bar
„
groove.
Position the chain so there is a loop at
„
the back of the bar.
Hold the chain in position on the bar
„
and place the loop around the sprocket
and make sure it is correctly mounted.
Make sure the bar hole fits well with
bolt for saw chain tension.
Replace the sprocket cover, turn the
„
chain tension adjust bolt clockwise until
the saw chain is properly tensioned.
The guide bar must then be pushed
upwards, check chain tension again,
do not tension the chain too tight.
After the chain is well-tensioned,
„
tighten the nuts again.
NOTE: The saw chain is properly ten-
sioned if, in the middle of the guide bar, it
can be lifted 3mm to 4mm from the edge
of the guide bar. Start the saw again with
a new saw chain, allowing it to run-in for
2~3 minutes.
After the run-in time, check the chain ten-
sion and retighten the chain if necessary.
2
WARNING