Fein BLS1.6E Mode D'emploi page 20

OBJ_BUCH-0000000109-001.book Page 19 Friday, June 7, 2013 10:26 AM
en
19
Turning or replacing cutting bars
Fig.15
(BSS1.6E) (figure 15).
5.
Loosen the screws with the hex key. Cutting bars
When the front half of the cutting edges on
4.
2.
the cutting bars are dull, turn the cutting bars
by 180° and mount them each to the opposite
1.
side.
When both cutting edge halves are dull, Screws
3.
replace the cutting bars.
5.
4.
2.
1.
3.
Replacing cutting bars (BSS2.0E)
Screws
Fig.16
(figure 16).
1. 5.
Loosen the screws with the hex key.
Cutting bars
Remove the cutting bars and mount new
ones.
2.
3.
4.
6.