Fein BLS1.6E Mode D'emploi page 15

OBJ_BUCH-0000000109-001.book Page 14 Friday, June 7, 2013 10:26 AM
en
14
Clipping off the cut chip (BSS1.6CE)
Fig.8
(figure 8).
Clip off the chip by turning the chip-cutter
actuator (3/4 turn in clockwise direction)
1.
while the machine is running. To continue
working, reset the chip-cutter actuator to the
starting position.
Note: Do not continue to work with a broken
2.
off chip brake! Replace the chip cutter.
For cut-outs, pull the power tool from the
chip while the motor is running. Cut long
chips off.
Chip cutter
Chip-cutter actuator
3.
4.
Adjusting the cutting stroke (BLS3.5)
Fig.9
(figure 9).
Adjust the desired clearance with the dial
control.
Material Curved cut Straight cut
thickness
0.5 mm
1 mm –
1.5 mm –
2 mm –
2.5 mm –
3 mm Dial control
3.5 mm
Cutter blade