Fein BLS1.6E Mode D'emploi page 17

OBJ_BUCH-0000000109-001.book Page 16 Friday, June 7, 2013 10:26 AM
en
16
Changing the tool(BSS).
Before mounting or replacing cutting tool or accessories, pull the power plug.
WARNING
This preventive safety measure rules out the danger of injuries through acciden-
tal starting of the power tool.
BSS1.6E, BSS1.6CE: Cutter blades and cutting
bars cannot be reground.
Replacing cutter blades (BSS1.6E)
(figure 11).
Press the engaged supporting pin out in lateral
direction until the cutter blade can be
removed.
Pull the cutter blade out of the cutter head.
Lightly grease the supporting pin and the new
cutter blade.
Insert the new cutter blade. Slide the support-
ing pin through the hole of the cutter blade
until it engages.
Replacing cutter blades (BSS1.6CE)
(figure 12).
Remove one of the two retaining rings from
the supporting pin using a screw driver.
Press the engaged supporting pin out in lateral
direction until the cutter blade can be
removed.
Pull the cutter blade out of the cutter head.
Lightly grease the supporting pin and the new
cutter blade.
Insert the new cutter blade. Slide the support-
ing pin through the hole of the cutter blade
until it engages.
Reinsert the retaining ring into the corre-
sponding groove of the supporting pin.
BSS2.0E: Cutter blades and cutting bars can be
reground.
Fig.11
4.
3.
2.
5.
Supporting pin
4.
Fig.12
5.
4.
1.
6.
8.
Supporting pin
Retaining ring
5.
Cutter blade
4.
1.
6.
Cutter blade
5.
3.
2.
7.