Publicité
Les langues disponibles
Les langues disponibles
OBJ_BUCH-0000000109-001.book Page 17 Friday, June 7, 2013 10:26 AM
en
17
Replacing cutter blades (BSS2.0E)
Fig.13
(figure 13).
Retaining ring
For stationary operation, clamp the power
Washer
tool in a vice using aluminum or plastic pro-
tection jaws. Tighten the vice adequately so
that the application tool is clamped firmly yet
not damaged.
3.
1.
Remove one of the two retaining rings and
the corresponding washer from the support-
ing pin using a screwdriver.
Pull out the supporting pin and remove the
Supporting pin
cutter blade.
2.
Lightly grease the supporting pin and the new
cutter blade.
Insert the new cutter blade. Slide the support-
ing pin through the hole of the cutter blade.
Mount the washer and reinsert the retaining
ring into the corresponding groove of the
supporting pin.
Cutter blade
5.
5.
6.
5.
4.
7.
9.
8.
Publicité
