Functional Testing - Kemper MINI-TRESOR Instructions D'installation Et D'utilisation

EN 5
Fill insert rail with clear silicon
1.
Push the trim frame with door (9) with the lateral guide slots over the
(pre-assembled) screws, until the frame lies flush with the outer wall of
the building.
2.
Then secure the trim frame with door (9) using the screws.
The integral flap for hose and cable connection is for safety purposes uring use.
Installation of the trim frame with
door to the built-in wall cabinet
6

Functional testing

1.
Conduct functional testing of the frost-proof outer fitting (3).
Note!
Due to the automatic draining of the frost-proof outer fitting (3)
after removal of water, water will continue to drain out for a few
seconds after closing the fitting (frost safety). For this reason, the
fitting only needs to be closed gently.
Note!
To ensure the correct 'frost safety' function, hoses and other
attachements must be removed before the start of the frost
period!
© www.kemper-olpe.de – 11.2021 / K410021100001-00 – 13 /32