Lubrication - Campbell Hausfeld TF2101 Instructions D'utilisation

Single Phase / Three Phase
Wiring Diagram
Ground
L3 (for 3 phase wiring only)
L2
L1
Motor
Figure 3 - For Motor Frame Sizes
R56HZ, Y56Y or L143T.
Refer to Motor Nameplate
Operation
IMPORTANT: Check motor rotation
before operating the compressor.
All lubricated compressor pumps
discharge some condensed water
and oil with the compressed air.
Install appropriate water/oil removal
equipment and controls as necessary for
the intended application.
Failure to install
appropriate water /
oil removal equipment may result in
damage to machinery or workpiece.
GUARDING
The
belt
guard provided must
be installed before
operating the unit.
All moving parts must be guarded.
All electrical covers must be installed
before turning on the power.

LUBRICATION

THIS UNIT
CONTAINS NO OIL.
Before operating compressor, fill
crankcase with compressor oil
according to the oil capacity chart.
Some residual oil may still be in the
pump leaving a thin coat on the sight
glass, however; there is not enough
oil to operate the unit. Fill pump with
single-viscosity, ISO100, non-detergent,
compressor oil.
TF2101, TF2111, TQ3010, TQ3011, TX2101, TX2118
Single Phase
Wiring Diagram
Circuit
Breaker
or Fused
Disconnect
L1
Pressure
Coil
Switch
X2
Thermal
Unit
T1
Motor
Figure 4 - For Motor Frame Sizes 184T, 215T, 254T or 284T.
Refer to Motor Nameplate
Use part number ST126700AV,
compressor oil or Mobil 1 ®
10W30 synthetic oil may also be used.
Add oil only through the oil fill plug.
Pouring oil into any other orifice will
cause oil to leak and spray out during
operation.
Breather
Cap
Oil Fill
Plug
Oil Drain
Plug
Dipstick and
Oil Fill
Drain on
side
Figure 5 - Oil Fill Diagrams
5
Circuit
Breaker
or Fused
Disconnect
L2
Over
Load
Pressure
Switch
T2
Fill to the center of the sight gauge or
5W30 or maximum mark on dipstick (see
Figure 5).
shorten pump life and damage
valves.
Breather
Cap
Sight Gauge
Full
Low
Max
Low
Fill
Line
Dipstick and
Oil Fill
Drain
Three Phase
Wiring Diagram
L1 L2
L3
Coil
X2
Over
Thermal
Load
Units (3)
T3
T1
T2
Motor
Using any other
type of oil may
Oil Fill
Oil
Plug
Drain
Plug