Assembly; Lubrication; Air Filter; Operation - Campbell Hausfeld CE2002 Serie Instructions D'utilisation Et Manuel De Pièces

Operating Instructions and Parts Manual

Assembly

lubRicAtion

This compressor is shipped with oil�
Remove cap from oil fill opening� See Figure 4� Install breather (found in
parts bag with this manual)� See Figure 5� Check oil level� See specification
label on compressor pump for the proper oil capacity and oil type�
Do not use regular automotive oil� Additives in regular motor oil can cause
valve deposits and reduce pump life� For maximum pump life, drain and
replace oil after the first hour of run time�
This pump has an oil sight glass as shown in Figure 5� Oil level can be
monitored and maintained as shown in Figure 3, page 5�
Refer to engine manual for proper oil level and type�
Recommended oil
Full synthetic compressor oil from Campbell Hausfeld (Item #CE0032)
Alternate oil
- 10W30 Synthetic oil
- Single viscosity, non-detergent compressor oil SAE30/ISO100�
Available from Campbell Hausfeld (Item #ST126700AV)
oil capacity
CE2002 � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � Approximately 8�5 oz�

AiR filteR

Install air filter� See Figure 5�

Operation

Before starting the compressor, thoroughly read all component
instruction manuals, especially the engine manual.
All lubricated compressor pumps discharge some condensed water and oil with the
compressed air� Install appropriate water/oil removal equipment and controls as
necessary for the intended application�
Failure to install appropriate water/oil removal equipment may result
in damage to machinery or workpiece.
Drain liquid from tank daily.
Do not attach air tools to open end of the hose until start-up is
completed and unit checks OK.
6 www.campbellhausfeld.com
figure 4
Oil Drain
Sight Glass
Plug
figure 5
Cap
Air Filter
Breather
Oil Fill Area