Drive Belt - Campbell Hausfeld CE2002 Serie Instructions D'utilisation Et Manuel De Pièces

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

Maintenance (Continued)

dRive belt

Belt stretch is a result of normal use� When properly adjusted, the belt deflects about
1/2 inch with five pounds of pressure applied midway between the engine pulley and
pump�
To adjust drive belt tension:
1� Remove belt guard and loosen engine brace�
2� Loosen the four fasteners holding the engine to the baseplate�
3� Shift the engine in the proper direction� The belt must be properly aligned when
adjustment is made�
4� To align belt, lay a straight edge against the face of the flywheel, touching the rim at
two places�
5� Adjust flywheel or engine pulley so that the belt runs parallel to the straight edge�
6� Use a gear puller to move the pulley on the shaft and tighten fasteners�
7� Adjust brace and reinstall belt guard�
StoRAGe
1� When not in use, hose and compressor should be stored in a cool, dry place�
2� Tanks should be drained of moisture�
3� Hose should be disconnected and hung with open ends down to allow any moisture
to drain�
Series CE2002
1/2 inch Deflection
figure 10
Belt
figure 11
www.campbellhausfeld.com
Straight
edge
Touch Rim
of Flywheel
in Two
Places
9

Publicité

Table des Matières
loading

Table des Matières