Lubrication - Campbell Hausfeld CE7002 Mode D'emploi

Installation (Continued)

lubriCation

THIS UNIT CONTAINS NO OIL. Before operating
compressor, fill to the center of the sight gauge
(see Figure 6).
Using any other type of oil may shorten pump
life and damage valves.
recommended oil (2 options)
• Single viscosity SAE 30 ISO100 non-detergent compressor
oil. Available from Campbell Hausfeld, part number
ST126701AV.
• 10W30 synthetic oil such as Mobil 1
oil Capacity
CE7000 Series� � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � 2 quarts
Fill the pump with oil to the center of the sight gauge using oil
fill opening (see Figure 6). Do NOT fill the pump through the
breather cap opening as this may cause oil to leak and spray
out during operation.
NOTE: Some residual oil may still be in the pump from factory
testing leaving a thin coat on the sight gauge; however, there is
not enough oil to operate the unit�
�
®
Models CE7002, CE7003, CE7004
oil fill plug
oil drain plug
SigHt gauge
figure 6
Full
Low
www.CH-Commercial.com 7