Unpacking; Installation - Campbell Hausfeld CE7002 Mode D'emploi

Unpacking

Do not lift or move unit without appropriately rated equipment. Be sure
the unit is securely attached to lifting device used. Do not lift unit by
holding onto tubes or coolers. Do not use unit to lift other attached equipment.
After unpacking the unit, inspect carefully for any damage that may have occurred
during transit� Check for loose, missing or damaged parts� Check to be sure all supplied
accessories are enclosed with the unit� In case of questions, damaged or missing parts,
please call 1-888-606-5587 for customer assistance.
Do not operate unit if damaged during shipping, handling or use.
Damage may result in bursting and cause injury or property damage.
required iteMS - not inCluded
Oil
◆
Vibration Isolator Pads
◆

Installation

Disconnect the battery cable on models with electric start
and release all pressure from the system before attempting to
install, service, relocate or perform any maintenance.
Do not lift or move unit without appropriately rated
equipment. Be sure the unit is securely attached to lifting
device used. Do not lift unit by holding onto tubes or coolers. Do not use unit to lift other
attached equipment.
Never use the wood shipping skids for mounting the compressor.
piCking tHe loCation
Do not locate the compressor air inlet near steam, paint spray, sandblast
areas or any other source of contamination.
The compressor should be installed on a foundation of sufficient strength and rigidity
to support it without vibrating� It is recommended to use shims under the mounting
feet to level the compressor, to prevent "rocking" and excessive vibration� To reduce
vibration, isolator pads are recommended� When isolators are used, install a flexible
coupling between the tank and any pipe permanently attached to the tank�
When permanently installing compressor for stationary use or mobile
use such as on a truck, avoid overstressing a mounting foot by "pulling
the foot down" to the floor. This may cause eventual failure.
Models CE7002, CE7003, CE7004
figure 2 - isolator pad
www.CH-Commercial.com 5