Compressor Lubrication; Engine Lubrication - Campbell Hausfeld CE7003TD Serie Mode D'emploi

Installation (Continued)

COMPRESSOR LUBRICATION

THIS UNIT CONTAINS NO OIL. Before operating
compressor, fi ll to the center of the sight gauge
(see Figure 5).
Using any other type of oil may shorten pump
life and damage valves.
Recommended Oil (2 Options)
• Single viscosity SAE 30 ISO100 non-detergent compressor
oil. Available from Campbell Hausfeld, part number
ST126700AV.
• 10W30 synthetic oil such as Mobil 1
Oil Capacity
CE7003TD . . . . . . . . . . . . . . . . . . . . . . . . . .Approximately 2 quarts
Fill the pump with oil to the center of the sight gauge using oil
fill opening (see Figure 5). Do NOT fill the pump through the
breather cap opening as this may cause oil to leak and spray
out during operation.
NOTE: Some residual oil may still be in the pump from factory
testing leaving a thin coat on the sight gauge; however, there is
not enough oil to operate the unit.

ENGINE LUBRICATION

This unit is shipped without oil. Before operating, oil must
be added. See the engine manual for recommended engine
lubrication.
FILLING ENGINE WITH GASOLINE
Refer to engine manual for instructions on filling fuel tank with
gasoline.
® .
Oil Fill Plug
Oil Drain Plug
SIGHT GAUGE
Figure 5
Series CE7003TD
Full
Low
www.campbellhausfeld.com 7