Inserting The Bobbin - ELNA elnaStar Livret D'instructions

z
q
x
c
r
v
t
b
w
e
y
26

Inserting the bobbin

z Place the bobbin in the bobbin holder with the
thread running off counterclockwise.
q Thread
w Bobbin holder
x Guide the thread into the notch on the front of the
bobbin holder.
e Notch on the front
c Draw the thread to the left, sliding it between
the tension spring blades.
r Spring blades
v Continue to draw the thread lightly until the thread
slips into the notch on the side.
t Notch on the side
b Pull out about 4" (10 cm) of thread to the rear.
Reattach the hook cover plate.
NOTE:
A threading chart is shown on the hook cover plate
for your reference.
y Threading chart