Inserting The Bobbin - ELNA eXperience 660 Mode D'emploi

Inserting the Bobbin

Place the bobbin in the bobbin case with the thread
running counterclockwise.
Guide the thread into notch on the front side of the
A
bobbin case.
Hold the bobbin with your right hand and pull the thread
to the left, through the tension spring blades.
A
Continue pulling the thread lightly until the thread slips
into notch .
B
Pull out about 15 cm (6˝) of thread.
B
Replace the bobbin cover plate.
Refer to the chart shown on the bobbin cover plate to
check the threading.
24