PULOX PO-210B Mode D'emploi page 11

Pulse Oximeter tester) could measure the available pulse wave with the amplitude of 6% of the
simulation pulse wave amplitude.
11. Interference Resistance Capacity against ambient light: Device works normally when BIO-TEK INDEX
Oximeter tester exerts interfering signal test.
Classification
1. Management Class for Medical Devices: II Equipment
2. Anti-electric Shock Type: Internally powered equipment
3. Anti-electric Shock Degree: Type BF equipment
Maintenance and Preservation
1. Charge batteries timely when the battery power is too low.
2. Clean the surface of fingertip oximeter before it is used to diagnose patients.
3. It is recommended to preserve the product in -10 - 40°C (14 - 104°F) and humidity is 10%-80%.
4. It is recommended that the product should be kept dry any time. A wet ambience might affect its
lifetime and even damage the product.
Product Accessories
1. User manual
2. Charging cable
3. Adapter (optional)
Guidance and Manufacturer's Declaration - Electromagnetic Radiation for Other Equipments
and Systems
The Pulse Oximeter is designed to be used in specified electromagnetic environment. Users of the
Pulse Oximeter must use it in the following environments.
Radiation Test
RF-interference CISPR 11
RF-interference CISPR 11
Troubleshooting
Problem
The SpO2 and Pulse Rate can
not be shown normally
The SpO2 and Pulse Rate are
shown unsteadily
The device can not be turned
on
Display is suddenly off
Compliance
Group 1
Class B
Possible Reason
1. Finger is not properly
positioned
2. Patient's SpO2 is too low to
be measured.
1. Finger is not placed inside
deep enough.
2. Finger is trembling or the
patient is moving.
1. Inadequate power or power
off.
2. Oximeter might be damaged.
1. The device automatically
Electromagnetic environment
guidance
RF signal of Pulse Oximeter is
simply created by its internal
function. Therefore, its RF
interference is very low and is
not likely to cause any
interference to nearby
electronic equipment.
The Pulse Oximeter applies to
all establishments, including
domestic establishments and
those directly connected to the
public low-voltage power supply
network that supplies buildings
used for domestic purposes.
Solution
1. Place the finger properly and
try again.
2. Try again; If you are sure the
device works all right, go to a
hospital timely for exact
diagnosis.
1. Place the finger properly and
try again.
2. Please remain at rest.
1. Charge battery timely.
3. Please contact the local
customer service.
1. Normal.
EN