PULOX PO-210B Mode D'emploi page 10

Parameter setup
Press start button (>3s), into parameter setup as menu 1.
1. In menu 1, when the "*" signal is shown on the "Alm Setup", press the button (>3s) and enter into
the menu 2. Press the button (<1s) can select item, then press button (>3s) to set the on/off for
prompt, beep, demo and screen brightness adjustment (optional 1, 2, 3 und 4). When the "*" signal
is shown on the "Restore", press the button (>3s) and all settings are back to factory settings.
Attention
Using devices outdoors or under strong light, please adjust the screen brightness to a higher proper
level for observation. It's better for user to choose a lower brightness to conserve battery power.
2. In menu 2, when the "*" signal is shown on the "Sounds Setup", press the button (>3s) and enter
into the menu 1. Press the button (<1s) can select item, then press button (>3s) to setup data.
Choose + or – to plus or minus values.
Detailed Description of Product Functions
1. Display type: OLED-Display
2. SpO2 Measurement range: 70%—99%
Accuracy: ±2% on the SpO2 80%-99%:
± 3% on the SpO2 70%-79%
Below 70% no requirement
Resolution: ± 1%
3. PR Measurement range: 30BPM-240BPM
Accuracy ± 1BPM or ±1%(the larger one)
4. Parameters of LED probe
Red light: Wavelength 660 ± 2nm, Radiation power 1.8mW
IR light: Wavelength 905 ± 10nm, Radiation power 2.0mW
5. Power: Rechargeable lithium battery
6. Automatic standby: The product shuts off by itself when no finger is inserted for about 8 seconds.
7. Dimension: 44mm x 28,3mm x 26,5mm
8. Operation environment: Operation temperature: 5°C - 40°C
Storage temperature: -10°C - 40°C
Ambient humidity: 15%-80% in operation
Air pressure: 86kPa-106kPa
9. Declaration: EMC of this product comply with IEC60601-1-2 standard.
10. Measurement Performance in Low Perfusion Condition: Required test equipment (BIO-TEK INDEX
Menu 1
10%-80% in storage
Menu 2
EN