Ego Power+ ST1500F Guide D'utilisation page 24

2. Press the release tabs on the spool
retainer and remove the spool
retainer by pulling it straight out
(Fig. 17 & 18).
3. Remove the cutting line from the
spool retainer.
4. With one hand holding the spool
base, use another hand to grasp the
spool retainer and align the tabs on
the spool retainer with the holes in
the spool base; use your palm to
press and rotate the spool retainer
left and right until the tabs lock with
the spool base. (Fig. 19 & 20).
5. Following the instructions in "LINE
REPLACEMENT" to reload the
cutting line.
24
56-VOLT LITHIUM-ION CORDLESS 15" STRING TRIMMER
17
Release tab
18
Spool Retainer
19
20
Spool Base
Alignment