Removing The Rechargeable Battery - Remington TouchTech Beard Trimmer MB4700 Mode D'emploi

REMOVING THE RECHARGEABLE BATTERY

We strongly recommend that a professional removes the rechargeable battery. Parts of the
case, and tools have sharp edges and may cause injury if not handled correctly.
• The rechargeable battery must be removed from the appliance before it is scrapped.
• Disconnect the charging adapter before removing the battery.
1. Ensure that the battery is fully discharged. To do this, operate the trimmer until it stops.
2. Remove blade then remove the two screws (FIG A).
3. Use an appropriate tool to prise off the front cover trim (FIG B) at the points indicated
(ut).
4. Remove the four screws (FIG C).
5. Unclip then lift off the display cover (FIG D).
6. Unclip the circuit board (FIG E) and move it aside.
7. Lift out the battery and cut the two wires (FIG F).
• The battery must be disposed of at an appropriate official recycling/collection point.
• Do not attempt to operate the trimmer once you have opened it.
RECYCLING
W
To avoid environmental and health problems due to hazardous
substances, appliances and rechargeable and non-rechargeable
batteries marked with one of these symbols must not be disposed of
with unsorted municipal waste. Always dispose of electrical and
electronic products and, where applicable, rechargeable and
non-rechargeable batteries, at an appropriate official recycling/
collection point.
ENGLISH
GB
DE
NL
FR
ES
IT
DK
SE
FI
PT
SK
CZ
PL
HU
RU
TR
RO
GR
SI
HR
UA
BG
AE
9