Tuner; Tuning To Radio Stations; Storing Radio Stations; Tuning To Preset Stations - Philips FW-R33 Mode D'emploi

DISP LAY

Tuning to radio stations

1
Press TUNER to select the tuner.
TUNER is scrolled.
2
Press TUNER again to select the desired waveband.
The selected waveband is displayed.
3 Keep à SEARCH or á SEARCH pressed for more than
half a second.
The selected waveband and SEARCHING are displayed.
The radio tunes to a station with sufficient signal strength.
4
Repeat searching until you find the desired station.
To tune to a weak station, briefly press à SEARCH or
0 0
á SEARCH as often as necessary for optimum reception.

Storing radio stations

It is possible to store up to 40 radio stations. Stations can be
selected and programmed automatically or you can do that
yourself. Programming will overwrite your former presets
starting from the last active preset station. After programming
the last preset stored will be tuned.
Automatic programming
If no preset is tuned, automatic programming starts at
preset number 1.
1
Follow steps 1 and 2 of "Tuning to radio stations".
2
Keep PROG pressed for more than 2 seconds.
AUTOPROGRAM is displayed and
All available radio stations for the selected waveband are
stored automatically,
PROG
the waveband and the frequency of the last preset
station are displayed briefly.
AUX
is shown.
PROG
goes off, the preset number,
To store radio stations for another waveband, repeat
0 0
steps 1–2. Make sure to select the next available preset
number first before proceeding, otherwise, already
programmed radio stations may be erased.
To exit the automatic programming press Ç.
0 0
Note: Strong stations always will automatically be programmed
first, followed by the weak stations.
Manual programming
1
Follow steps 1 and 2 of "Tuning to radio stations".
2
Keep PROG pressed for less than 2 seconds.
starts flashing.
PROG
3 Press à SEARCH or á SEARCH to tune to the desired
radio station.
To allocate the radio station to another preset number,
0 0
rotate í JOG CONTROL ë.
4
Press YES to confirm the setting and to exit the manual
programming.
goes off, the preset number, the waveband and the
PROG
frequency of the preset station are displayed.
To delete the current preset, press NO.
0 0

Tuning to preset stations

Use í JOG CONTROL ë until the preset number of
the desired station is displayed.

Tuner

25