Using The Sleep Timer; Tone Control; Adjust Brightness Of Front Panel Display - Yamaha ISX-800 Mode D'emploi

You can set the time to turn off the system automatically.
Top panel
iPod
Remote control

ADJUST BRIGHTNESS OF FRONT PANEL DISPLAY

Rear panel

USING THE SLEEP TIMER

AUTO 2 SET 2 BEEP
1 1 SOURC
DIMMER CLOCK ALARM T
USB LABEL SIDE
VOLUME SOURCE ALARM SNOOZE SLEEP
1

TONE CONTROL

3
2
1
2 1 AUTO
1
Press SNOOZE/SLEEP a number of times to set
the time until the system turns off.
The sleep timer can be set to 30, 60, 90 and 120 minutes.
When the time is set, the sleep indicator (
front panel display.
y
If you press SNOOZE/SLEEP while the sleep timer is activated, the
sleep timer setting will be canceled.
1
Press one of the LOW/MID/HIGH EQ buttons on
the remote control while playing back.
Select the tone to be adjusted (LOW, MID, HIGH).
iPod
2
Press to adjust the tone.
/
Each tone can be adjusted from –5 to +5.
3
Press ENTER to complete settings.
You can also press the EQ button that you pressed in Step 1
to complete the settings.
To change the tone of other audio frequencies, return to step
1 and press the EQ button to adjust the desired frequency.
1
Adjust the brightness with the DIMMER switch on
the rear panel.
AUTO: adjusts the brightness automatically to match the
surroundings.
1: brighter.
2: darker.
Note
When Auto is set, the brightness of the front panel display is adjusted
automatically with the brightness sensor (P. 3). Ensure that the sensor is
not covered.
) is shown on the
Tone
: HIGH
Tone
： MID
Setting
： LOW
17
En