Initial Use - Beurer IH25 Mode D'emploi

5

Initial use

Setup
Remove the unit from the packaging. Pla-
ce it on a flat surface.
Ensure that the ventilation slits are free.
Before using the unit for the first time
Note:
• Before you use the unit and accessories
for the first time, clean it thoroughly. The
same applies if you haven't used the de-
vice for a prolonged period. See
"Cleaning and maintenance" on page
28.
• Attach the hose [15] at the bottom of the
nebuliser [11].
• Connect the other end of the hose [15]
to the hose connector [6] on the inhaler
by lightly turning it.
Mains connection
Connect the unit only to the mains voltage
listed on the type plate.
• Insert the mains cable plug [3] into a
suitable socket.
• Push the plug completely into the mains
socket.
Note:
• Ensure that there is a socket near to
where the unit will stand.
• Lay the mains cable in such a way
that no one can trip over it.
• To disconnect the inhaler from the
mains after use, first switch off the
device and then remove the plug from
the socket.
23