DeWalt DCV580 Guide D'utilisation page 12

Installing and Removing the
Battery Pack (Fig. 3)
NOTE: Make sure your battery pack is fully
charged.
To install the battery pack into the vaccum,
insert/slide battery pack into battery port (A).
Make sure the battery pack is fully seated.
To remove the battery pack from the
vacuum, press and hold the battery release
on the battery pack and remove. To charge the
pack, insert it into your D WALT charger.
E
Using the Appliance (Fig. 2, 4)
1 Attach the appropriate accessory to
the hose (B).
2. Insert the D WALT battery pack.
E
3. To turn machine on, press the I/O
(on/off) button (C).
Vacuum Cleaning
TO EMPTY TANK (FIG. 5)
The sound of the motor changes and
suction is reduced when the tank is full.
1. Turn machine off and remove the
battery pack.
2. Unlatch the tank latches (D) and
remove the power head from the
tank.
3. Empty the contents of the tank into
a suitable container.
4. Clean or change filters. See Filter
section of this manual.
5. Inspect machine for damage by foreign objects. Contact the
FIG. 3
6. Replace power head onto the tank and latch securely.
NOTE: The machine must be used in the upright position at all times
to prevent unwanted actuation of the Automatic Vacuum Shutoff. If
unwanted actuation should happen, turn off the motor and wait until
the motor stops turning. Turn the motor on again and suction will be
restored.
Filter (Fig. 6)
A
FILTER CARE
The wet/dry filter (E) included with this vacuum is a long life filter. To be
effective in minimizing dust recirculation the filters MUST be installed
FIG. 4
correctly and in good condition.
NOTE: Never operate without a filter in place. A clean filter is the most
important factor in the operation and efficiency of any vacuum. If the
filter becomes clogged beyond cleaning, damaged, or fails to operate
properly, replace only with genuine D
TO CLEAN OR CHANGE THE FILTER
FIG. 5
1. Turn the machine off and
2. Unlatch the tank latches (D)
E
D
10
nearest D WALT authorized service center for replacement of
E
damaged or missing parts.
E
remove the battery pack.
and remove the power head
from the tank. Twist the filter
(E) to the right to remove it
from the power head.
WALT replacement filters.
FIG. 6
E