Winix ZERO AZBU330-HWE Manuel D'utilisation page 14

FILTER CARE
2. Removing Filters
Turn the unit power off before removing filters.
Remove the front panel by grasping its
①
upper edge and gently pulling forward.
Press on the Pre-filter tabs near the top of
②
the filter, release and remove.
③ Pull out the Carbon filter and True HEPA
Filter.
3. Preparing New Filters
Remove replacement filters from protective
①
plastic wrap.
ˍ Operating the unit without removing
filters from plastic wrap may cause
abnormal noise, deformation, or fire as a
result of overheating.
NOTICE
English
ˍ For optimal performance, only Winix filters should be used
with this unit.
Latch
Tabs
Pre- lter
ZERO
14