Operation - Ryobi RY42102 Manuel D'utilisation

WARNING:
Do not connect to power supply until assembly is
complete. Failure to comply could result in accidental
starting and possible serious personal injury.
WARNING:
Do not allow familiarity with products to make you
careless. Remember that a careless fraction of a second
is sufficient to inflict serious injury.
WARNING:
Always wear eye protection with side shields marked to
comply with ANSI Z87.1, along with hearing protection.
Failure to do so could result in objects being thrown into
your eyes, resulting in possible serious injury.
WARNING:
Do not use any attachments or accessories not
recommended by the manufacturer of this product. The
use of attachments or accessories not recommended
can result in serious personal injury.
NOTICE:
Before each use, inspect the entire product for damaged,
missing, or loose parts such as screws, nuts, bolts, caps,
etc. Tighten securely all fasteners and caps and do not
operate this product until all missing or damaged parts
are replaced. Please contact customer service or an
authorized service center for assistance.
ASSEMBLY
ASSEMBLING THE BLOWER TUBE
See Figure 2.
 Slide blower tube forward until the tabs on the blower
housing click into the slots on the tube.
 To remove the tube, depress the tabs on the blower
housing and remove the tube.

OPERATION

APPLICATIONS
You may use this product for the purposes listed below:
 Clearing leaves and other debris from your lawn
 Keeping decks and driveways free from leaves and pine
needles and other debris
STARTING/STOPPING THE BLOWER
See Figures 3 - 4.
NOTICE:
Always secure extension cord to unit by using cord
retainer. Failure to use cord retainer may result in damage
to the unit and/or extension cord.
 Attach the outlet end of an extension cord to the plug on
the rear of the blower.
NOTE: Use only an approved outdoor extension cord as
described previously in this manual.
 Form a loop with the extension cord.
 Insert the loop portion of the extension cord up through
the opening at the rear of the blower handle and place
over the cord retainer.
 Slowly pull loop against cord retainer until the slack is
removed.
 To start the blower, place the power switch in either the
LOW (1) or HIGH (2) position.
 To stop the blower, place the power switch in the OFF
position.
7 — English