Basic Functions; Switching On And Off; Adjusting The Volume; Selecting The Input Source - Siemens KG28FM50/01 Notice D'utilisation

Basic functions

Switching on and off

Switching on:
S Switch on the power switch (0/1) at
the rear of the appliance (1).
The LCD TV switches to standby
mode and the power lamp lights up
red.
S Press the POWER button
remote control or the power button
on the front control panel.
The power lamp lights up green and
the other six indicator lamps light up
blue.
After six seconds, a picture appears on
the screen.
Switching off:
S Press the POWER button
remote control or the power button
on the front control panel.
The LCD TV switches to standby
mode and the power lamp lights up
red.
S If you wish to switch off the LCD TV
completely, switch the power switch
(0/1) off (0).
32
Selecting a TV channel
Press the CH + or CH − button on the
remote control or the channel − or
channel + button on the LCD TV to
change the channel.
Using the number buttons on the
remote control
How to select a one−digit channel
number (e.g. channel 5):
Press button 5.
How to select a two−digit channel
number (e.g. channel 20):
Press and hold the −/−− button until −−
appears. Then press buttons 2 and 0
consecutively.
on your
How to select a three−digit channel
number (e.g. channel 103):
Press and hold the −/−− button until −−−
appears. Then press buttons 1, 0 and
3 consecutively.

Adjusting the volume

Press the VOL + or VOL − button on
the remote control or the volume + or
volume − button on the LCD TV to
on your
adjust the volume.
Caution!
Excessive volume may cause
hearing damage.
Mute
You can mute the audio output at any
time.
Press the MUTE button on the remote
control and the audio output is
switched off (MUTE ON).
The MUTE logo
right corner of the screen.
Press the MUTE button again and the
audio output is switched back on
(MUTE OFF).
Selecting the input
source
Using the remote control:
S Press the TV/AV button.
The menu for selecting the input
source appears.
S Select an input source by pressing
the Y or B button.
S To confirm your selection, press
ENTER.
Using the control elements on the
LCD TV:
S Press the source button. The menu
for selecting the input source
appears.
S Select an input source by pressing
the channel − and channel +
buttons.
S To confirm your selection, press the
volume + button.
Sequence of input sources:
TV " USB " AV1 " DTV.
appears in the top