IKA T 65 D ULTRA-TURRAX Mode D'emploi page 24

Technical data
S 65 KG-HH-
Working range
Stator diameter
Rotor diameter
Circumferential speed
Min./ Max. immersion depth
Shaft length
Materials in contact
with medium
pH range
Suitable for solvents
Suitable for abrasive substances
Max. temperature
Sterilization methods
Working range vacuum
Working range pressure
Ultimate fi neness, suspensions
Ultimate fi neness, emulsions
Slide ring seal
O-rings
Other parts
Subject to technical changes!
Quantity details
The quantities processed are limited, in particular,
by the viscosity of the medium:
Viscosity
0,001 Pas
0,1 Pas
1,0 Pas
5,0 Pas
At higher viscosities, a breakdown of the fl ow
and dry-running conditions for the seal must be
expected.
Consideration of fl ow anomalies
The quantity details given above apply for New-
tonian fl uids. Processing of substances with thi-
xotropic or dilatant (shear thickening) behaviour
is possible, but the particular volumes must al-
ways be determined by trials.
G 65 G
2 l - 50 l
65 mm
58 mm
21,9 m/s
90 mm / 450 mm
520 mm
FFPM / SIC, 1.4571
2 - 13
yes
no
180 °C
wet chemical
1 mbar
6 bar
25 µm - 75 µm
5 µm - 25 µm
Tungsten carbide
+ 6 % cobalt
FKM
Stainless steel 1.4571 Stainless steel 1.4571 Stainless steel 1.4571
Volume
max. 30 l
max.10 l
max. 5 l
max. 3 l
G 65 M
2 l - 40 l
65 mm
58 mm
21,9 m/s
80 mm / 450 mm 80 mm / 450 mm
510 mm
FFPM / SIC, 1.4571 FFPM / SIC, 1.4571
2 - 13
yes
no
180 °C
wet chemical
1 mbar
6 bar
20 µm - 50 µm
5 µm - 15 µm
Tungsten carbide Tungsten carbide
+ 6 % cobalt
FKM
G 65 F
2 l - 30 l
65 mm
58 mm
21,9 m/s
500 mm
2 - 13
yes
no
180 °C
wet chemical
1 mbar
6 bar
5 µm - 20 µm
1 µm - 10 µm
+ 6 % cobalt
FKM
24