Bosch GO Professional Notice Originale page 11

Charger
– AU
Battery charging voltage
Charge current
Protection class
Assembly
Before any work on the power tool (e.g. maintenance, tool change, etc.) as well
u
as during transport and storage, set the rotational direction switch to the middle
position. There is a risk of injury if the power tool is started up accidentally.
Battery Charging (see figure A)
Note: The battery is supplied partially charged. To ensure the maximum performance of
the battery, use the power adaptor to fully charge the battery before first use.
The lithium-ion battery can be charged at any time without reducing its service life. Inter-
rupting the charging process does not damage the battery.
The lithium-ion battery is protected against deep discharge by the "Electronic Cell Pro-
tection (ECP)". When the battery is discharged, the power tool is switched off by means
of a protective circuit: The application tool stops moving.
Do not continue to apply pressure to the spindle after the power tool has auto-
u
matically switched itself off. This can damage the battery.
Do not continue to press the On/Off switch after the power tool has automatic-
u
ally switched off. The battery can be damaged.
Use a USB cable (9) to connect the power tool to the power supply (10).
The battery charge indicator (6) indicates the charging progress. The indicator flashes
green during the charging process. When the battery is fully charged, the indicator is lit
up green continuously.
During the charging process, the handle of the power tool will become warm. This is nor-
mal.
If you are not planning to use the power tool again soon, disconnect it from the power
supply.
The power tool cannot be used during the charging process. It is not defective if it does
not work during the charging process.
Follow the instructions on correct disposal.
Bosch Power Tools
English | 11
2 609 120 717
V
mA 1000
1 609 92A 6M5 | (21.05.2021)
5
/ II