Maintenance And Cleaning - Norcold N2000 Serie Mode D'emploi

12. Maintenance and cleaning

Norcold recommends an annual inspection service by an approved service center. Clean the
refrigerator on a regular basis.
Always remove any spills or contamination immediately with a mild dish detergent and soft
•
cloth.
If needed, remove the shelves, door bins, vegetable bins and clean the inside of the
•
refrigerator and loose parts.
Clean the outside of the refrigerator with a damp soft cloth.
•
Do not use abrasive cleaners, metal scouring pads or hard brushes. They could damage
the refrigerator.
Never clean the refrigerator with soap or aggressive, caustic or soda−based cleaning
agents.
Dry any water with a dry soft cloth.
The loose parts of the refrigerator are not suitable for the dishwasher.
Only for refrigerators installed on floor level: Dust underneath the refrigerator might block
the airflow required for a proper performance. Therefore, frequently remove all dust from
this area, e.g. using a vacuum cleaner.
Only for refrigerators installed on floor level: We recommend to remove the refrigerator
once every 2 years to completely clean and remove all dust from both the refrigerator and
the aperture. In a dusty environment we recommend doing this every year.
We recommend to clean the condenser once every 2 years for N2175 and N2160 refrigerators.
Blow the dust from the condenser with slightly pressurized air. In a dusty environment we
recommend doing this every year. For other models this can be done if you suspect bad
performance. Accessing the condenser can be done by removing the front guard for model N2175
and N2160. For N2090 and N2152 the refrigerator must be removed to access the condenser.
Removing slide-out box system (N2152, N2175, N2160)
To remove the slide−out box system:
Completely open the refrigerator door and remove the slide−out box, by pulling the
•
slide−out box towards you while you tilt the box upwards.
Push the rail system to the right, as illustrated.
•
13
EN