Electronic Adjustment; Use Of Dishwasher Salt - Zanussi ZDT101 Notice D'utilisation

1

Electronic adjustment

The water softener is set at the factory at level 5.
1. Switch on the appliance.
2. Make sure that the appliance is in setting mode.
3. Press and hold the programme selection/cancel but-
ton.

Use of dishwasher salt

Caution! Only use dishwashers salt. Types of salt
that are not applicable for dishwashers cause
damage to the water softener.
1
3
Fill the salt container with
1 litre of water (only the
first operation).
22
2
Set switch to position 1 or
2.
2
4
4. Release the programme selection/cancel button
when programme indicator light A starts to flash and
programme indicator light B comes on.
5. Wait until programme indicator light B goes off.
– Programme indicator light A starts to flash.
– The end indicator light starts to flash.
6. Press the programme selection/cancel button one
time.
– Programme indicator light A starts to flash.
– The setting function of the water softener is acti-
vated.
– The end indicator light flashes to show the level
of the water softener.
Example: 5 flashes, pause, 5 flashes, pause, etc...
= level 5.
7. Press the programme selection/cancel button one
time to increase the water softener level by one step.
8. Press the on/off button to save the operation.
5
It is normal that water overflows from the salt con-
tainer when you fill it with salt.
Make sure that there is no grain of salt outer of the
salt compartment. Salt which stays on the tank for
a while drills the tank. It is recommended to start a wash-
ing programme immediately after you fill the salt con-
tainer. This prevents of corrosion because of spilled salt.
When you set electronically the water softener to level 1,
the salt indicator light does not stay on.
6