Programme Selection/Cancel Button; Setting Mode; Audible Signals - Zanussi ZDT101 Notice D'utilisation

End
1) When the salt container is empty, the related indicator light does not come on while a washing programme operates.

Programme selection/cancel button

Use the programme selection/cancel button for these op-
erations:
• To set the washing programme. Refer to the chapter
'Setting and starting a washing programme'.
• To set the water softener. Refer to the chapter 'Setting
the water softener'.
• To deactivate/activate the audible signals. Refer to the
section 'Audible signals'.
• To cancel a washing programme in progress. Refer to
the chapter 'Setting and starting a washing pro-
gramme'.
Half-load button
The half-load option is not available for all washing pro-
grammes. Refer to the chapter 'Washing programmes'.
• Load dishes in the upper and lower basket.
• Decrease the detergent dosage when you use the half-
load option.
• Press the half-load button to set the option.
– The half-load indicator light comes on, when the
half-load option is selectable.
With the half-load button pressed the time duration
and the consumption of water and energy are re-
duced.

Setting mode

The appliance is in setting mode when all the programme
indicator lights are off and the end indicator light flashes.
The appliance must be in setting mode for these opera-
tions:
– To set a washing programme.
– To set the water softener level.
– To deactivate/activate the audible signals.
If a programme indicator light is on, cancel the pro-
gramme to go back to the setting mode. Refer to the
chapter "Setting and starting a washing programme".
Indicator lights
The indicator light comes on when the washing pro-
gramme is completed. Auxiliary functions:
• Level of the water softener.
• Activation/deactivation the audible signals.
• An alarm if the appliance has a malfunction.
Programme indicator lights A and B
Apart the selection of the corresponding washing pro-
gramme, these lights have an auxiliary functions:
• The adjustment of the water softener level.
• Deactivation/activation of the audible signals.

Audible signals

You can hear an audible signal:
• At the end of the washing programme.
• When the appliance has a malfunction.
The activation of the audible signals is set at the factory.
Do these steps to deactivate the audible signals:
1. Switch on the appliance.
2. Make sure that the appliance is in setting mode.
3. Press and hold the programme selection/cancel but-
ton until programme indicator light A flashes and
programme indicator light B comes on.
4. Press the programme selection/cancel button again.
– Programme indicator light A comes on.
– Programme indicator light B starts to flash.
5. Wait until programme indicator light A goes off.
– Programme indicator light B continues to flash.
– The end indicator light comes on.
The audible signals are activated.
6. Press the programme selection/cancel button again.
– The end indicator light goes off.
The audible signals are deactivated.
7. Switch off the appliance to save the operation.
Do these steps to activate the audible signals:
1. Do the above procedure until the end indicator light
comes on.
19