Manual Adjustment; Electronic Adjustment; Use Of Dishwasher Salt - Zanussi ZDT110 Notice D'utilisation

°dH °TH
43 - 50 76 - 90
37 - 42 65 - 75
29 - 36 51 - 64
23 - 28 40 - 50
19 - 22 33 - 39
15 - 18 26 - 32
11 - 14 19 - 25
4 - 10 7 - 18
< 4 < 7
1) No use of salt required.
You must set the water softener manually and elec-
tronically.

Manual adjustment

The appliance is set at the factory at position 2.
1

Electronic adjustment

The water softener is set at the factory at level 5.
1. Switch on the appliance.
2. Make sure that the appliance is in setting mode.

Use of dishwasher salt

Caution! Only use dishwashers salt. Types of salt
that are not applicable for dishwashers cause
damage to the water softener.
Water hardness
mmol/l
7,6 - 9,0
6,5 - 7,5
5,1 - 6,4
4,0 - 5,0
3,3 - 3,9
2,6 - 3,2
1,9 - 2,5
0,7 - 1,8
< 0,7
2
Set switch to position 1 or
2.
Clarke manually
53 - 63 2
46 - 52 2
36 - 45 2
28 - 35 2
23 - 27 2
18 - 22 1
13 - 17 1
5 - 12 1
< 5 1)
1
3. Press and hold the programme selection/cancel but-
ton.
4. Release the programme selection/cancel button
when programme indicator light A starts to flash and
programme indicator light B comes on.
5. Wait until programme indicator light B goes off.
– Programme indicator light A starts to flash.
– The end indicator light starts to flash.
6. Press the programme selection/cancel button one
time.
– Programme indicator light A starts to flash.
– The setting function of the water softener is acti-
vated.
– The end indicator light flashes to show the level
of the water softener.
Example: 5 flashes, pause, 5 flashes, pause, etc...
= level 5.
7. Press the programme selection/cancel button one
time to increase the water softener level by one step.
8. Press the on/off button to save the operation.
Water hardness setting
electronically
9
8
7
6
5
4
3
2
1)
1
21