Operation - Safety Guidelines - Enduro autoSteady AS101 Manuel D'utilisateur

NOTE: This constant e cable power source (+12V) CANNOT be in direct connection with the
caravan battery! Check this very carefully, otherwise the autoSteady system will not work!
You can test this by disconnecting the connector from the car so the constant +12V voltage
drops. By connecting the connector on the car again, the +12V voltage will be restored. If
you have doubts you can drop this option (it is not obliged).
Route the cable for the emergency draw back function (18) from the constant power source (+12V) to control
unit (6).
Again it is recommended to use the supplied trunking (26) to protect the cables against sharp edges. Attach the
cable and trunking with the cable ties (17) or P-Clips (14 & 15) and mounting screws for P-Clip (13).
Cut the cables to the correct length. Remove approx 5mm of the insulation from the end. Fix the spade
connectors (23) by using crimping pliers. A secure and good quality connection on each cable is essential.
Connect the cable for emergency draw back function (18) to the control unit (6).
Installation of the autoSteady system is now complete.

OPERATION - SAFETY GUIDELINES

Practice operating the autoSteady system before using for the first time. This is to fully familiarise yourself with
the remote control and the autoSteady system operation.
Before use, always check the autoSteady system for any damage.
Always ensure that children and pets are kept well out of the way during operation.
When operating the system, ensure that no hairs, fingers or other body parts, clothing or any other
objects carried on the body can become trapped by moving or rotating parts.
Do not use the autoSteady system to jack up your caravan. Just as the standard corner steady of your
caravan can only be used for stabilising, also the autoSteady system cannot be used for jacking up
your caravan.
Before using the autoSteady system always make sure that your caravan is levelled out in all
directions.
In the event of malfunctions, turn off the main isolation power switch immediately.
To maintain signal strength, always make sure that, during action, the distance between the remote
control and the caravan does not exceed 5 metres.
Due to the nature of a radio signals, external terrain or objects can interfere and reduce the
effectiveness. So there may be small areas around the caravan where the quality of reception reduces,
hence the autoSteady system may stop momentarily.
Always be aware that the autoSteady system increases the weight of your caravan. So this reduces
the payload of the caravan.
Always make sure that all the corner steady are fully drawn back before towing/moving the caravan.
This can damage the corner steady, caravan or the towing vehicle.
Always make sure that after you have finished using the autoSteady system, the battery power
isolation switch (24) is switched off and the key is removed and stored in a safe place (out of reach of
children or other unauthorised people). If you don't switch off, the battery will be discharged by the
small "standby" current.
Always apply the handbrake during action.
Always make sure that the remote control is stored in a safe place (out of reach of children or other
unauthorized people). If you don't switch off, the battery will be discharged by the small "standby"
current.
Do not exceed the total safe working load of the laden weight of the original corner steady.
Sensitive objects such as cameras, DVD-Players etc. must not be kept in the storage box near the
control unit or the motor cable. They can be damaged by the electromagnetic fields.
EN ® autoSteady 32
DURO
Ref: AS101-UM-TKI-1212-Rev. A