14.1.
Jumper removal
Remove the jumper from the terminal strip in the electrical panel for cabinet-mounted
compressors. The switch on the compressor cabinet will not work properly if the jumper is
not removed!
Remove the cover on the electrical panel
Remove the jumper from the terminal strip
Reinstall the cover on the electrical panel
Keep the removed jumper for service purposes (see Chapter 19.11 - Jumper connections).
Compressor with jumper installed
Compressor with jumper removed
NP-DK50 2x2V 110-2_10-2018-MD A
- 22 -
DK50 2x2V/110
10/2018