Control Panel; Front Manifold Panel And Knobs; Cleaning The Exterior; Stainless Steel Surfaces - LG LRGL5825 Serie Manuel Du Propriétaire

46 MAINTENANCE

Control Panel

To prevent activating the control panel during cleaning,
unplug the range. Clean up splatters with a damp
cloth using a glass cleaner. Remove heavier soil with
warm, soapy water. Do not use abrasives of any kind.
CAUTION
Do not use the cooktop at high temperatures for
an excessive period as the control panel could be
damaged.
NOTE
When spraying on the glass surface, intermittent
touch operation is possible.

Front Manifold Panel and Knobs

It is best to clean the manifold panel after each use
of the range. For cleaning, use a damp cloth and mild
soapy water or a 50/50 solution of vinegar and water.
For rinsing, use clean water and polish dry with a soft
cloth.
CAUTION
• Do not use abrasive cleansers, strong liquid
cleaners, plastic scouring pads or oven
cleaners on the manifold panel. Doing so will
damage the finish.
• Do not try to bend the knobs by pulling them up
or down, and do not hang a towel or other objects
on them. This can damage the gas valve shaft.
• The control knobs may be removed for easy
cleaning.
• To clean the knobs, make sure that they are in
the Off position and pull them straight off the
stems.
• To replace the knobs, make sure the knob has
the Off position centered at the top, and slide
the knob directly onto the stem.
NOTE
To prevent scratching, do not use abrasive
cleaners on any of these materials.

Cleaning the Exterior

Painted and Decorative Trim
For general cleaning, use a cloth with hot soapy
water. For more difficult soils and built-up grease,
apply a liquid detergent directly onto the soil. Leave it
on for 30 to 60 minutes. Rinse with a damp cloth and
dry. Do not use abrasive cleaners.

Stainless Steel Surfaces

To avoid scratches, do not use steel wool pads.
1
Place a small amount of stainless steel appliance
cleaner or polish on a damp cloth or paper towel.
2
Clean a small area, rubbing with the grain of the
stainless steel if applicable.
3
Dry and buff with a clean, dry paper towel or soft
cloth.
4
Repeat as necessary.
NOTE
• Do not use a steel wool pad; it will scratch the
surface.
• To clean the stainless steel surface, use warm
sudsy water or a stainless steel cleaner or
polish.
• Always wipe in the direction of the metal
surface finish.
• To purchase stainless steel appliance cleaner
or polish, or to locate a dealer near you, call our
toll-free customer service number:
1-800-243-0000 (USA),
1-888-542-2623(CANADA)
or visit our website at: www.lg.com
Oven Door
• Use soapy water to thoroughly clean the oven door.
Rinse well. Do not immerse the door in water.
• You may use a glass cleaner on the outside glass
of the oven door. Do not spray water or glass
cleaner on the door vents.
• Do not use oven cleaners, cleaning powders, or
harsh abrasive cleaning materials on the outside of
the oven door.
• Do not clean the oven door gasket. The oven door
gasket is made of a woven material that is essential
for a good seal. Care should be taken not to rub,
damage, or remove this gasket.
CAUTION
Do not use harsh cleaners or harsh abrasive
cleaning materials on the outside of the oven
door. Doing so can cause damage.
Don't hand
clean oven
door gasket
Do hand
clean door