Microphone Setting Menu - dB Technologies INGENIA IG3T Caractéristiques Techniques

English

MICROPHONE SETTING MENU

IG3T allows the input of a microphone with XLR connector. When using
this source, it may be useful to apply a filtering to the signal to cut any
unwanted frequencies (by a high-pass filter with adjustable cut frequency).
Or it may be necessary to intervene (by a notch or band-stop filter with
selectable band centre) to prevent any feedback (or Larsen effect). To
perform one of these settings, or both of them, after accessing the
MICROPHONE SETTING menu:
1. Select and confirm HP filter (high-pass filter)
2. Select and confirm the value of the high-pass filter cut frequency, with
a range of 50 Hz – 200 Hz and a resolution of 10 Hz (select the "None"
value if you wish to disable the filter)
3. Select and confirm "Antifeedback" (anti-feedback or anti-Larsen effect
filter)
4. Select and confirm the value of the band centre frequency, with a
range of 260 Hz – 15000 Hz and a resolution of 10 Hz (select the
"None" value if you wish to disable the filter)
5. Return to the initial screen by selecting the "HOME" symbol
INGENIA IG3T
Wide indoor environment setting
Microphone Setting Menu
Cod. 420120239 REV. 1.1
59