Switch (Only For Hp Series) - Urmet NVR Boost 2.0 Série Guide Rapide

Check that the DDNS function is enabled and that the URMETDDNS server is selected. Click on the Get button and
wait for ten seconds or so for the NVR ID to be generated. This is needed for remote access via the URMET web
portal (see below).
Take note of the ID of your NVR provided by the URMETDDNS server.
IMPORTANT NOTE:
A DDNS server other than URMETDDNS can be used. Select from the available options in
the list. See the instructions on the user manual of the device and those of the DDNS quick
guide ("DDNS Configuration Guide it_en") which can be downloaded from the Urmet
website for more information.
At this point, save changes by clicking on [Apply], quit the OSD menu of the NVR and restart the device at the prompt.
Wait for the device to reboot.
IMPORTANT NOTE:
See the respective sections on the user manual available on the CD provided with the product for more
information on the network menu and the mobile phone and the Internet configuration menu.
6.2.2

Switch (only for HP Series)

It is possible to set the NVR Ref. 1093/908HP and Ref. 1093/916HP as switch mode. If IP Camera is set in different net,
this option allows to connect them, if IP Address, SubNet Mask and Gateway are set.
DS1093-133B 44