Urmet NVR Boost 2.0 Série Guide Rapide page 43

Press APPLY to save the changes.
The NVR parameters must be allocated manually if the network does not support DHCP. Select "Type =
b)
Static" on the "Menu
DNS.
Press APPLY to save the changes.
IMPORTANT NOTE:
The DNS fields must be filled in correctly for correct operation of the DDNS system.
Port setup
2.
At this point the external doors of the router must be forwarded to the NVR. The function is usually called "Port-
forwarding" or "Virtual Server" in the router configuration menu. The ports set on the router must correspond to those of
the NVR.
Set different values on the NVR if the default ports of the NVR (80, 9000, 18600) are already in use in the
a)
port-forwarding table of the router.
Set the ports on the NVR and port-forward of the same ports to the router. There are two different ways to
b)
do this:
Automatic mode: If the UPnP function is supported and enabled on the router, simply enable the
function also on the NVR on the bottom of the "Menu
Manual mode: if the UPnP function cannot be used, manually set port-forwarding on the port-
forwarding (or virtual server) table of the router.
IMPORTANT NOTE:
The firewall of some routers could block forwarding of the ports set on port-forwarding
tables. Carefully check the firewall settings of your router too.
Urmet DDNS Setup
3.
Select the DDNS submenu in the NVR network menu. A page like the following will appear:
IMPORTANT NOTE:
Before to get Urmet DDNS ID it is mandatory to enable the user and password (refer to pictures
below).
DS1093-133B
Network" and fill in the following fields: IP address, subnet mask, gateway and
43
Network" page.