Urmet NVR Boost 2.0 Série Guide Rapide page 40

In the window displayed, change the IP address [Type], from [DHCP] to [Static], as shown in the figure below, then
manually assign the network parameter: [IP address] ([Mask] and [Gateway] shoud not change).
After each Network settings Camera saving, select [Refresh] button in order to upgrade the display of new parameters
set.
WARNING: before assigning a static IP address to the camera, check that this address:
Has not been already assigned to another device on the LAN network, for example by the command [IP address
ping] available in a MS-DOS command shell of a Windows operating system based PC.
Is not included in the IP address interval reserved for the router DHCP server (see the router instruction manual).
DS1093-133B 40