Bosch GLM 30 Consignes D'utilisation/De Sécurité page 13

Length Measurement
For length measurements, repeatedly press the button 4 until the
indicator for length measurement appears on the display 1.
Press the measuring button 2 for a new measurement on the
bottom line.
Press the measuring button 2 and the measurement from the
middle line will move to the top line and the measurement from
the bottom line will move to the middle line.
Press the measuring button 2 for a new measurement on the
bottom line. The last three measurements will display on the
bottom, middle, and top lines.
Area Measurement
For area measurements, repeatedly press button 4 until the
indicator for area measurement
Then measure the width and length one after the other as with a
length measurement.
The first measured value will be shown at the top of the
display. The laser beam remains switched on between the two
measurements.
Volume Measurement
For volume measurements, repeatedly press button 4 until the
indicator for volume measurement
Then measure the width, length and depth one after the other as
with a length measurement.
The first measured value will be shown at the top of the display.
The laser beam remains switched on between the three
measurements.
To measure, press the measuring button 2. The
measurement will be shown on the bottom of the
display.
Press the measuring button 2 and the previous
measurement will move to the middle line.
After the second measurement has been
completed, the area will be automatically
calculated and displayed. The end result will be
shown at the bottom of the display, while the
current measured value will be shown above it.
appears on the display 1.
appears on the display 1.
-13-