Operation - Inventum AKB9015ZWA Manuel D'utilisation

INSTALLING THE SHAFT
Preliminary requirements
• Screws Ø 3.9 mm x 9.5 mm (4x)
Procedure
1. Put the shaft (A) on the appliance (B).
2. Move the top part of the shaft up.
3. Install the screws (C).
CONNECTING THE APPLIANCE
Caution:
If you wish to make a fixed connection, make sure that there is an omnipolar switch with a minimum
contact separation of 3 mm installed in the supply cable.
1. Make sure that the voltage in your home corresponds with the voltage of the appliance.
2. Use the supplied mains cable to connect the appliance to the mains socket.
5

Operation

STARTING THE APPLIANCE
1. It is advised that you start the appliance a few minutes before you start cooking.
2. Touch the up button to start the appliance. The appliance starts at speed 1 and the display also shows 1.
ADJUSTING THE SPEED
1. Make sure that the appliance is on.
2. Use the up button to increase the speed. The display shows the set speed.
3. Use the down button to decrease the speed. The display shows the set speed.
USING THE BOOSTER MODE
The booster mode provides extra speed to the appliance.
1. Make sure that the appliance is on.
2. Use the up button to increase the speed until the display shows 4.
The booster mode now works for 5 minutes. After 5 minutes, the speed returns to 3.
USING THE AUTOMATIC SWITCH-OFF MODE
In automatic switch-off mode, the appliance automatically switches off after a set time.
Note:
For an overview of the amount of time for each level, refer to section
1. Make sure that the appliance is on.
2. Adjust the speed.
32 • English
(Figure 12)
'Automatic switch-off times'
.