Table des Matières
Publicité
Model 1000 Humidifier Installation Manual
Installation
1. Select a location on the vertical surface of warm air plenum
of a forced air handling system for mounting humidifier that
allows for service and maintenance. Do not install humidifier
where the blanked off ends of a cooling coil will restrict air
flow to the humidifier. Cut out a square section 12-1/8" tall
by 14-1/8" wide as shown.
2. Open the cover and remove the evaporator pad assembly.
The humidifier chassis is self retaining. Slide the top side
in first, then slide the chassis down. Level the chassis and
install the eight screws (included).
3. Mount the self tapping saddle valve on either a cold or a hot
water pipe. A side or top mount is best to avoid clogging
from pipe sediment. Connect 1/4" O.D. tubing to the saddle
valve. Copper tubing requires a brass compression nut and
brass sleeve. Plastic tubing requires a brass insert inside the
tubing in addition to a plastic ferrule and brass nut.
!
CAUTION: do not use plastic tubing on hot water or in
contact with any hot plenum surface or duct. Installation
of this saddle valve must meet or exceed local codes and
ordinances.
4.
Connect 1/4" water supply tube to inlet of solenoid.
Connect drain hose to 1/2" spout on humidifier cabinet using
hose clamp if necessary. Run 1/2" hose to suitable drain
such as floor drain, sewer or laundry sink. Be sure hose has
continuous slope and is not kinked at any point.
4
Breathe Healthier!
Residential Whole-House Indoor Air Quality
14-1/8"
COPPER
TUBING
Compression
Nut
PLASTIC
TUBING
Plastic
Sleeve
4
12-1/8"
1
2
Brass
Sleeve
Brass
Insert
Publicité
Table des Matières
