Table des Matières
Publicité
Installation Cont.
5. GCV3412 Code Valve Installation Instructions*
Copper Pipe:
!
1. CAUTION: Turn off water supply.
2. Clean pipe, fittings and valve with sandpaper or wire brush.
3. Apply a thin layer of flux to all surfaces to be soldered.
4. Assemble valve to pipe and/or fittings.
5. Cooling the valve by wrapping a wetted rag around the valve is optional.
!
For your safety, this should be performed by a
6. WARNING:
licensed contractor only.
each joint. Continue to apply heat sufficient to keep solder liquid.
7. After solder has filled entire joint area, remove heat and allow joint to cool. Do
not move or disturb.
8. Slide compression nut over 1/4" copper tube followed by compression sleeve.
9. Insert tube into valve fully and tighten nut.
10. Turn on water supply and check for leaks.
*Code Valve Is Included With Automatic Models Only
Installing The Control
GFX3 (Automatic Models)
HUMIDIFIER CONTROL LEADS
(YELLOW WIRES)
24V OUTPUT FROM HUMIDIFIER (RED WIRES) OR
727-58 24 V. TRANSFORMER WITH CONSTANT POWER
OR 24 VAC POWER SUPPLY WITH CONSTANT POWER
Heat the joints with a torch. Apply solder to
MHX3C (Manual Models)
OUTDOOR TEMP. SENSOR
(NOT USED IN MANUAL MODE)
Thick Gasket
DUCT MOUNT ONLY
Model 1000 Humidifier Installation Manual
FIG. 1
Face
1/2" TEE
3/4" TEE
Thin Gasket
DUCT MOUNT: Use
ONLY Outer Portion
WALL MOUNT: Use
Outer & Inner Portions
Mounting
Base
www.generalfilters.com
5
Publicité
Table des Matières
