Vortice VORT KRYO-POLAR EVO 11 Notice D'emploi Et D'entretien page 28

ENGLISH
Setting ventilation speed
Press SPEED button to choose the ventilation speed you need, high, medium or low. The sign of high or low
ventilation will light on at the same time.
Setting timer
1. Press TIMER button to set the operating hours you desired (1 to 24 hours, the sign of timer will light on).
When the set time has been reached, the machine will turn off automatically. The display window will show the
hour(s) you set as you press TIMER button. If the timer button is not pressed, the unit will work continuously.
2. By pressing the timer but without turning on the other functions, you can PRE-SET the time for the machine
to work. For example, if you press the timer to '2', the unit will work automatically after 2 hours.
SLEEP function
1. In cooling mode, by pressing the SLEEP button, the set temperature will increase 1°C at the 1st hour, ano-
ther 1°C at the second hour, then keeps at that temperature.
2. In heat mode, by pressing the SLEEP button, the set temperature will descend 1°C at the 1st hour, another
1°C at the second hour, then keeps at that temperature.
3. In sleep mode, the ventilation will keep at low speed. Re-press the SLEEP button, the setting temperature
and ventilation speed will return to the pre-selected one.
4. The unit will shut down automatically after the SLEEP function running for 12 hours.
NOTA: Please note, the sleep function is not available while the machine is working in ventilation, dehumidifi-
cation or auto mode. Only available in Cooling or Heating mode.(13 HP). When the machine is in Sleep fun-
ction, the Fan Speed would turn to be LOW speed.
Dehumidify (DRY) mode
In dehumidify (DRY) mode, the temperature cannot be adjusted, the ventilation will fix at low speed. When the
unit is operating in Dehumidify ( DRY) mode, humidity extracted from the air is collected in an internal tank. If
the tank reaches full, the compressor and motor cut out automatically. At the same time, the "Water Full" indi-
cator comes on. An alarm will also sound. When the tank is full, drain the water as shown in the page concer-
ning "DRAINAGE". You may also use the unit without having to empty the tank so often by using "continuous
drainage", please also refer to the page about "DRAINAGE".
Heating function (13 HP model)
Thanks to the presence of the heat pump the air in the room can be heated.
The Exhaust Pipe must be still fitted to allow the cold air to be removed in this mode & used in the usual way.
Also please fix the drainage to be continuous drainage (i.e. drain the water by water tube), because the con-
densed water will be collected quickly. Under this system, the machine can run at HIGH, MEDIUM or LOW
speed.
28