Maintenance; Replacement Of The Hose - Faicom MC Serie Notice D'utilisation Et D'entretien

IMPORTANT: Any maintenance operation shall be carried out by a suita-
bly trained staff, following carefully the information given in this manual.
Ensure that there is no tension in the spring before starting any opera-
tions inside the hose reel.
Always close the feeding of fluid to the machine before carrying out any maintenance on it.
Replace the flexible hose as soon as it shows any sign of wear and tear or of deterioration
due to the different conditions of the labour environment. We advise you to replace it every
year in case it is used for a few hours a week.
Replace the seal inside the revolving joint in case of losses due to wear and tear.
Any replacement of hose reel parts has to be done using original spare parts (see the spare
parts list).
We advise you to contact the manufacturer for any possible anomaly and before replacing
any part. After every maintenance operation, put again the eventual supports.

10 - MAINTENANCE

11 - REPLACEMENT OF THE HOSE

Replace the hose with another one of the same di-
mensions and characteristics.
11.1) Remove the hose rubber stopper and release
11.1
11.2) Loosen the swivel joint.
11.3) Loosen the two screws of the spring likage
11.4) Disassemble the 4 screws which lock the two
11.2
11.5) Take out the drum, unscrew the internal fitting
11.6) Assemble again the hose reel, by following
11.3
11.7) Go on as indicated at point 7.2 of the chapter:
11.4
WARNING! For safety reasons, ope-
rations of hose replacement must be
carried out at the bench.
the hose slowly until the spring is completely
unloaded.
shaft by a 10 wrench.
side bodies. Take out the side body and the
rollers support and unwind completely the
hose from the drum.
with the suitable wrench and mount the new
hose.
the above steps in reverse order. If that is the
case, grease the supports and the ratchet
hook. Put the hose rubber stop at about 50 cm
from the opposite end of the hose.
Mounting of the hose.
- 14 -
11.5