Lubrication; Environmental Protection - Ryobi EJS-710QEO Manuel D'utilisation

GB
F D
MAINTENANCE
The chips and grindings from these materials are highly
abrasive to electric tool parts such as bearings, brushes,
commutators, etc. Consequently, it is not recommended
that this tool be used for extended work on any fiberglass
material, wallboard or plaster. During any use on these
materials it is extremely important that the tool is cleaned
frequently by blowing with an air jet.

LUBRICATION

All of the bearings in this tool are lubricated with a
sufficient amount of high grade lubricant for the life of the
unit under normal operating conditions. Therefore,
no further lubrication is required.
CAUTION
Keep extension cords away from the cutting area
and position the cord so that it will not get caught
on lumber, tools, etc., during cutting operation.
WARNING
Check extension cords before each use, if
damaged replace immediately. Never use tool
with a damaged cord as touching the damaged
area could cause electrical shock resulting in
serious injury.
E I P NL S DK N FIN GR
English
Extension cords suitable for use with your saw are
available at your nearest service center.
LIVE TOOL INDICATOR
This tool features a live tool indicator (17) which
illuminates as soon as the tool is connected to the supply.
This warns the user that the tool is connected and will
operate when the switch is presse.

ENVIRONMENTAL PROTECTION

13
H CZ RUS
WARNING
Always wear safety goggles or safety glasses
with side shields during power tool operation
or when blowing dust. If operation is dusty, also
wear a dust mask.
Do not dispose of in general household
waste. Instead, dispose of in an
environmentally friendly way. Contact your
local recycling cetre ou council for advise.
Ryobi takes the care of the envrionment
very seriously.
RO HR
PL SLO TR