Assembly; Operation - Husqvarna BR600 Manuel D'utilisation

To assemble the attachment
1. Press one of the drum axles (A) onto one of the two
outgoing drive shafts from the gear housing (F).
Rotate the drum axle if necessary so that the pin
hole comes over the corresponding hole in the drive
shaft.
2. Fasten the roller shaft with locking pin (B).
3. Put one of the brush rollers (C) onto the assembled
shaft. Press in the roller until it stops.
4. Fasten the roller on the shaft with a cotter pin (D).
Press in the end slightly when assembling.
To use the attachment
1. Operate the product at full throttle/speed (or nearly
full throttle/speed) with the brush resting on the
surface.
Note: It is both tiring and unnecessary to lift or hold
the brush above the surface when working.
738 - 003 - 13.12.2019

Assembly

E
F
B
D
A
C

Operation

E
5. Repeat these steps to assemble the axle and roller
on the opposite side.
6. Mount the splash guard with the snap-on fasteners
(E).
Note: For assembling accessories on basic product,
refer to manual for basic product.
217