Measuring Procedure - VOLTCRAFT 306 Mode D'emploi

To obtain further information, please use the online-help of the "ThermoLog" pro-
gram.
Measuring procedure, Data transmission
Data transmission
A) General
We are (still) in the Main Menu. In this window, another small window appears, sho-
wing the text: "Cannot find any thermometer".
This message appears if the connected thermometer is switched off.
Switch on thermometer and click the "RETRY" item. If the message does not chan-
ge, there is a problem - either as regards the thermometer (battery ?) or the connec-
ting cable (perfect fit?) or the software installation (setup fault ?). Start anew and try
everything again.
The following message appears if the connection was established successfully
(depending on the computer):
"Serial Port : COM1
Model: Two Channel, K type thermometer"
Click "OK" to close the window.
In the "Main Menu" window, you can click wherever the mouse pointer is transfor-
med into a hand with forefinger:
The item "Graph" ("Real Time"), a graphic representation of the real time measure-
ment or
the "Control Panel" item, a representation of the operator panel of the thermometer
with display or
the "Tabular" item, a tabular progressive representation of the temperatures T1 and
T2, also in real time or
the item on the left center with tabular representation "Tabular", "Graph" and "Con-
trol Panel" in a window or
the "Data Logger" item, transfer of the saved data from the thermometer to the PC
or
the "Link Test" item, a test of the connection between the computer and the digital
thermometer or
the "Help" item, the so-called help file with menu guidance in German, but help texts
in English or
last but not least the "Exit" item to exit the program.
29